Technical data

232 Chapter 15
cdma2000 Programming Commands
Occupied Bandwidth (OBW)
cdma2000 Programming Commands
Occupied Bandwidth (OBW)
This section provides the remote control SCPI commands for the cdma2000 Occupied Bandwidth
(OBW) measurement from within the List Sequencer. This measurement is available only if you have the
cdma2000 measurement application licensed on the test set.
For more detailed information about the cdma2000 OBW measurement, refer to the online help
associated with the cdma2000 measurement application, which is also available in PDF format (“User’s
and Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series cdma2000 measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
OBW measurement SCPI commands
There is a set of SCPI commands available to program the cdma2000 OBW measurement when it is used
in the cdma2000 mode. To set up the cdma2000 measurements from within the Sequence Analyzer mode
you need to prefix the SCPI commands with LSEQuencer:C2K. For example, the [:SENSe]:OBWidth
part of the OBW SCPI commands are replaced with: [:SENSe]:LSEQuencer:C2K:OBWidth
The following commands are used to set up the OBW measurement.
[:SENSe]:LSEQuencer:LTETdd:OBWidth:BANDwidth[:RESolution]
[:SENSe]:LSEQuencer:LTETdd:OBWidth:BANDwidth:SHAPe
[:SENSe]:LSEQuencer:LTETdd:OBWidth:PERCent
[:SENSe]:LSEQuencer:LTETdd:OBWidth:XDB
CALCulate:[SENSe]:LSEQuencer:LTETdd:OBWidth:LIMit:FBLimit
CALCulate:[SENSe]:LSEQuencer:LTETdd:OBWidth:LIMit[:TEST]
[:SENSe]:LSEQuencer:LTETdd:OBWidth:FREQuency:SPAN
[:SENSe]:LSEQuencer:LTETdd:OBWidth:FREQuency:SPAN:FULL
[:SENSe]:LSEQuencer:LTETdd:OBWidth:FREQuency:SPAN:PREVious