Technical data

222 Chapter 14
W-CDMA Programming Commands
Loopback BER
W-CDMA Programming Commands
Loopback BER
This section provides the remote control SCPI commands for the W-CDMA Loopback BER
measurement from within the List Sequencer. This measurement is available only if you have the
W-CDMA measurement application licensed on the test set.
The W-CDMA Loopback BER measurement is based on the W-CDMA Code Domain Power
measurement (CDP) and uses the remote commands associated with that measurement.
For more detailed information about the CDP measurement, refer to the online help associated with the
W-CDMA measurement application, which is also available in pdf format on the Agilent website,
www.agilent.com/find/e6640a.
Loopback BER measurement SCPI commands
The following commands are used to set up the Loopback BER measurement from within the Sequence
Analyzer mode.
:CALCulate:LSEQuencer:WCDMa:CDPower:TYPE
:CALCulate:LSEQuencer:WCDMa:CDPower:SRATe
:CALCulate:LSEQuencer:WCDMa:CDPower:SPRead
[:SENSe]:LSEQuencer:WCDMa:CDPower:SYNC:MS
[:SENSe]:LSEQuencer:WCDMa:CDPower:SFORmat:MS
[:SENSe]:LSEQuencer:WCDMa:CDPower:PRACh:SIGNature
[:SENSe]:LSEQuencer:WCDMa:CDPower:SYNC:SCRamble:MS
[:SENSe]:LSEQuencer:WCDMa:CDPower:DPCH:MS:CONFigure
[:SENSe]:LSEQuencer:WCDMa:CDPower:SBOundary:MS
[:SENSe]:LSEQuencer:WCDMa:CDPower:SBOundary:LIST:MS:INIT
[:SENSe]:LSEQuencer:WCDMa:CDPower:SBOundary:LIST:MS:APPend
[:SENSe]:LSEQuencer:WCDMa:CDPower:SBOundary:LIST:MS:REPLace
[:SENSe]:LSEQuencer:WCDMa:CDPower:SBOundary:LIST:MS:CHANnel?
[:SENSe]:LSEQuencer:WCDMa:CDPower:SBOundary:LIST:MS:NCHANnels?
:CALCulate:LSEQuencer:WCDMa:CDPower:THSDpcch
:CALCulate:LSEQuencer:WCDMa:CDPower:DTXBurst
:CALCulate:LSEQuencer:WCDMa:CDPower:IQPHase:ROTation
:CALCulate:LSEQuencer:WCDMa:CDPower:SSLot:NUMBer
[:SENSe]:LSEQuencer:WCDMa:CDPower:SPECtrum
:CALCulate:LSEQuencer:WCDMa:CDPower:ASET:THReshold