Technical data

Chapter 14 219
W-CDMA Programming Commands
Phase Discontinuity
W-CDMA Programming Commands
Phase Discontinuity
This section provides the remote control SCPI commands for the W-CDMA Phase Discontinuity
measurement from within the List Sequencer. This measurement is available only if you have the
W-CDMA measurement application licensed on the test set.
For more detailed information about the Phase Discontinuity measurement, refer to the online help
associated with the W-CDMA measurement application, which is also available in PDF format (“User’s
and Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series W-CDMA measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
Phase Discontinuity measurement SCPI commands
NOTE The W-CDMA Phase Discontinuity measurement is taken from the W-CDMA UE Power
Control measurement, and is designated PCONtrol in SCPI for that reason.
There is a set of SCPI commands available to program the W-CDMA Phase Discontinuity measurement
when it is used in the W-CDMA mode. To set up the W-CDMA measurements from within the Sequence
Analyzer mode you need to prefix the SCPI commands with LSEQuencer:WCDMa. For example, the
[:SENSe]:PCONtrol part of the Phase Discontinuity SCPI commands are replaced with
[:SENSe]:LSEQuencer:WCDMa:PCONtrol.
The following commands are used to set up the Phase Discontinuity measurement.
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SLOT:FORMat
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SSLot[:STATe] OFF|ON|0|1
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SSLot:NUMBer
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:FILTer[:RRC][:STATe]
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SYNC:SCRamble
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:FILTer[:RRC]:ALPHa
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:CRATe
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SBOundary:MS
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SBOundary:LIST:MS:INIT
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SBOundary:LIST:MS:APPend
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SBOundary:LIST:MS:REPLace
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SBOundary:LIST:MS:CHANnel? <entry_id>
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:SBOundary:LIST:MS:NCHannels?
[:SENSe]:LSEQuencer:WCDMa:PCONtrol:MINTerval