Technical data

200 Chapter 13
GSM/EDGE Programming Commands
EDGE Loopback BER
GSM/EDGE Programming Commands
EDGE Loopback BER
This section provides the remote control SCPI commands for the EDGE Loopback BER measurement
from within the List Sequencer. This measurement is available only if you have the GSM/EDGE
measurement application licensed on the test set.
The EDGE Loopback BER measurement is based on the EDGE EVM measurement, and uses remote
commands associated with that measurement.
For more detailed information about the EDGE EVM measurement, refer to the online help associated
with the GSM/EDGE measurement application, which is also available in PDF format (“User’s and
Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
EDGE Loopback BER measurement SCPI commands
The following commands are used to set up the Loopback BER measurement from within the sequence
analyzer mode.
[:SENSe]:LSEQuencer:EDGE:EEVM:BSYNc:SOURce
[:SENSe]:LSEQuencer:EDGE:EEVM:DROop
[:SENSe]:LSEQuencer:EDGE:EEVM:FERRor:TRANge
[:SENSe]:LSEQuencer:EDGE:EEVM:BSYNC:PMODulation:ALIGnment
Loopback BER results
Index Result Parameter
0 Loopback bit error ratio.
1 Total tested bit number.
2 Failed bit number.
3 Reserve.