Technical data
196 Chapter 13
GSM/EDGE Programming Commands
EDGE Output RF Spectrum (ORFS)
GSM/EDGE Programming Commands
EDGE Output RF Spectrum (ORFS)
This section provides the remote control SCPI commands for the EDGE Output RF Spectrum (ORFS)
measurement from within the List Sequencer. This measurement is available only if you have the
GSM/EDGE measurement application licensed on the test set.
For more detailed information about the EDGE ORFS measurement, refer to the online help associated
with the GSM/EDGE measurement application, which is also available in PDF format (“User’s and
Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series GSM/EDGE measurement application,
which is available on the Agilent website, www.agilent.com/find/mxa.
EDGE ORFS measurement SCPI commands
There is a set of SCPI commands available to program the EDGE ORFS measurement when it is used in
the GSM/EDGE mode. To set up the GSM measurements from within the Sequence Analyzer mode you
need to prefix the SCPI commands with LSEQuencer:EDGE. For example, the
[:SENSe]:EORFSpectrum part of the EDGE ORFS SCPI commands are replaced with
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum.
The following commands are used to set up the ORFS measurement.
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:TYPE
MODulation|MSWitching|SWITching|FFModulation
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:MEASure MULTiple|SINGle|SWEPt
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:LIST:SELect CUSTom|SHORt|STANdard
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:OFRequency <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:WBNoise ON|OFF|1|0
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:BANDwidth[:RESolution]:MODulation:CA
RRier <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:BANDwidth[:RESolution]:MODulation:OF
FSet:CLOSe <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:BANDwidth[:RESolution]:MODulation:OF
FSet:FAR <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:BANDwidth[:RESolution]:SWITching:CAR
Rier <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:BANDwidth[:RESolution]:SWITching:OFF
Set:CLOSe <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:BANDwidth[:RESolution]:SWITching:OFF
Set:FAR <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:LIST:MODulation[:FREQuency] <freq>
[:SENSe]:LSEQuencer:EDGE:EORFSpectrum:LIST:MODulation:BANDwidth <freq>