Technical data

190 Chapter 13
GSM/EDGE Programming Commands
EDGE Power vs. Time (PvT)
GSM/EDGE Programming Commands
11 Detected Training Sequence Code (TSC) is the most recently detected TSC. The
returned value is 0~7 (Burst Type : Normal/Higher Symbol Rate (HSR)) if TSC
is detected. If TSC is not detected, the returned value is -999.0. If Amptd or
NONE (Power vs Time only) is specified in Sync Type, the returned value is
-999.0. In multi slot condition, the returned value is the detected TSC of the
specified slot (Time Slot ON) or the first evaluated slot (Time Slot OFF).
Note: The returned value in Sync (Synchronization Burst) is.
10 if (BN42, BN43..BN105) =
(1,0,1,1,1,0,0,1,0,1,1,0,0,0,1,0,0,0,0,0,0,1,0,0,0,0,0,0,1,
1,1,1,0,0,1,0,1,1,0,1,0,1,0,0,0,1,0,1,0,1,1,1,0,1,1,0,0,0,0,1,1,0,1,1)
11 if (BN42, BN43..BN105) =
(1,1,1,0,1,1,1,0,0,1,1,0,1,0,1,1,0,0,1,0,1,0,0,0,0,0,1,1,1,1,1,0,1,
1,1,1,0,1,0,0,0,1,1,1,1,1,1,0,1,1,0,0,1,0,1,1,0,0,0,1,0,1,0,1)
12 if (BN42, BN43..BN105) =
(1,1,1,0,1,1,0,0,0,0,1,1,0,1,1,1,0,1,0,1,0,0,0,1,0,1,0,1,1,0,
1,0,0,1,1,1,1,0,0,0,0,0,0,1,0,0,0,0,0,0,1,0,0,0,1,1,0,1,0,0,1,1,1,0)
The returned value in Access (Access Burst) is
20 if (BN8, BN9..BN48) =
(0,1,0,0,1,0,1,1,0,1,1,1,1,1,1,1,1,0,0,1,1,0,0,1,1,0,1,0,1,0,1,0,0,0,1,1,1,1,0,0,0)
21 if (BN8, BN9..BN48) =
(0,1,0,1,0,1,0,0,1,1,1,1,1,0,0,0,1,0,0,0,0,1,1,0,0,0,1,0,1,1,1,1,0,0,1,0,0,1,1,0,1)
22 if (BN8, BN9..BN48) =
(1,1,1,0,1,1,1,1,0,0,1,0,0,1,1,1,0,1,0,1,0,1,1,0,0,0,0,0,1,1,0,1,1,0,1,1,1,0,1,1,1)
12 Detected Mod scheme is the most recently detected modulation scheme. The
returned value is as follows:
0 for GMSK
1 for Normal Burst (NB) 8PSK
2 for NB 16QAM
3 for NB 32QAM
11 for higher symbol rate burst (HB) QPSK
12 for HB 16QAM
13 for HB 32QAM
13 Estimated Carrier power (ECP) in dBm
14 Time Offset Power Results in dB
If averaged number N = 1, the power measured and calculated at Offset Times
relative to the mean power across the useful part of the burst.
If averaged number N > 1, Time Offset Results return the limit margin worst
case results. That is, 12 time offset results of the burst which has the worst limit
margin are returned.
12 Time Offsets can be set by SCPI commands.