Technical data

Chapter 1 19
What is the Sequence Analyzer?
Sequence Setup
What is the Sequence Analyzer?
Sequence Setup
There are a number of ways to set up a Sequence in the test set. The possibilities are described in these
chapters:
• Front panel setup - see Chapter 6 , “Front Panel Sequence Setup,” on page 77
• Spreadsheet setup - see Chapter 7 , “List Sequencer Spreadsheet Data Entry,” on page 91
• Remote setup - see Chapter 10 , “Programming a Sequence,” on page 137 for an example of how to
write a program to set up a Sequence.
See the following chapters for programming commands which are specific to the Sequence Analyzer.
— Chapter 12 , “Basic Measurements Programming Commands,” on page 171
— Chapter 13 , “GSM/EDGE Programming Commands,” on page 181
— Chapter 14 , “W-CDMA Programming Commands,” on page 201
— Chapter 15 , “cdma2000 Programming Commands,” on page 225
— Chapter 16 , “1xEV-DO Programming Commands,” on page 239
— Chapter 17 , “LTE-FDD Programming Commands,” on page 253
— Chapter 18 , “LTE-TDD Programming Commands,” on page 273
— Chapter 19 , “TD-SCDMA Programming Commands,” on page 297
Also, for a more complete SCPI command reference information, refer to the Sequence Analyzer
online help which is available on the test set and also available in pdf format as the “User’s and
Programmer’s Reference” on the C drive of the test set in the C:\Program
Files\Agilent\SignalAnalysis\Infrastructure\Help\bookfiles directory.
To find out how to set up the test set to perform measurements in modes other than the Sequence
Analyzer, refer to the equivalent measurement guides for the modes on the X-series analyzers which are
available at:
http://www.agilent.com/find/mxa
These measurement guides contain the required procedural information
Be aware that the X-series analyzer measurement guides refer to a separate analyzer and signal
generator. For the case of the Agilent EXM test set, the signal generator capability is available on the test
set, so the setup procedures should be adjusted accordingly.
For programming information for the other modes on the test set, refer to the mode online help which is
available on the test set and also available in pdf format as the “User’s and Programmer’s Reference” on
the C drive of the test set in the C:\Program Files\Agilent\SignalAnalysis\Infrastructure\Help\bookfiles
directory.
General programming for the X-series products is documented in the X-series programming guide.