Technical data

Chapter 13 183
GSM/EDGE Programming Commands
GMSK Phase and Frequency (PFER)
GSM/EDGE Programming Commands
GMSK Phase and Frequency (PFER)
This section provides the remote control SCPI commands for the GMSK Phase and Frequency (PFER)
measurement from within the List Sequencer. This measurement is available only if you have the
GSM/EDGE measurement application licensed on the test set.
For more detailed information about the GMSK PFER measurement, refer to the online help associated
with the GSM/EDGE measurement application, which is also available in PDF format (“User’s and
Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series GSM/EDGE measurement application,
which is available on the Agilent website, www.agilent.com/find/mxa.
PFER measurement SCPI commands
There is a set of SCPI commands available to program the GMSK PFER measurement when it is used in
the GSM/EDGE mode. To set up the GSM measurements from within the Sequence Analyzer mode you
need to prefix the SCPI commands with LSEQuencer:EDGE. For example, the [:SENSe]:PFERror
part of the PFER SCPI commands are replaced with: [:SENSe]:LSEQuencer:EDGE:PFERror
NOTE “EDGE” (and not “GSM”) is used to designate the GSM/EDGE mode in commands
The following commands are used to set up the PFER measurement.
[:SENSe]:LSEQuencer:EDGE:PFERror:BSYNc:SOURce
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:TEST[:STATe]
OFF|ON|0|1
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:BTS:RPHase
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:MS:RPHase
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:BTS:PPHase
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:MS:PPHase
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:BTS:FERRor
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:MBTS:FERRor
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:PBTS:FERRor
:CALCulate:LSEQuencer:EDGE:PFERror:LIMit:MS:FERRor