Technical data

Chapter 9 115
Sequence Setup Commands
Programming Analyzer Sequences (Parameter-Specific Commands)
Sequence Setup Commands
To set an LTE FDD Radio Band:
To set an LTE TDD Radio Band:
SCPI Command (for specifying
an LTE FDD radio band)
To set the radio band as an individual value:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND
NONE|BAND1|BAND2|BAND3|BAND4|BAND5|BAND6|BAND7|BAND8|
BAND9|BAND10|BAND11|BAND12|BAND13|BAND14|BAND17|BAND18|
BAND19|BAND20|BAND21|BAND24|BAND25|BAND26|BAND27|
BAND28|BAND31
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND?
To set the radio band as an array:
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND
<enum>,<enum>,<enum>,…
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND?
The array form of the command is used to make a different setting for each
acquisition in the sequence (the number of array values must match the
number of acquisitions; otherwise a "settings conflict" error will occur).
SCPI Examples (for specifying
an LTE FDD radio band)
:LSEQ:ACQ2:SET:RAD:BAND NONE
:LSEQ:ACQ2:SET:RAD:BAND?
:LSEQ:LIST:SET:RAD:BAND BAND1, NONE, BAND24, BAND21
:LSEQ:LIST:SET:RAD:BAND?
SCPI Command (for specifying
an LTE TDD radio band)
To set the radio band as an individual value:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND
NONE|BAND33|BAND34|BAND35|BAND36|BAND37|BAND38|BAND39|B
AND40|BAND41|BAND42|BAND43|BAND44
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND?
To set the radio band as an array:
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND
<enum>,<enum>,<enum>,…
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND?
The array form of the command is used to make a different setting for each
acquisition in the sequence (the number of array values must match the
number of acquisitions; otherwise a "settings conflict" error will occur).
SCPI Examples (for specifying
an LTE TDD radio band)
:LSEQ:ACQ2:SET:RAD:BAND NONE
:LSEQ:ACQ2:SET:RAD:BAND?
:LSEQ:LIST:SET:RAD:BAND BAND33, NONE, BAND34, BAND41
:LSEQ:LIST:SET:RAD:BAND?