Technical data

Chapter 9 113
Sequence Setup Commands
Programming Analyzer Sequences (Parameter-Specific Commands)
Sequence Setup Commands
To set an EDGE Radio Band:
To set a WCDMA/HSPA Radio Band:
SCPI Command (for specifying
an EDGE radio band)
To set the radio band as an individual value:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND
NONE|PGSM|EGSM|RGSM|DCS1800|PCS1900|TGSM810|GSM450|
GSM480|GSM700|GSM850
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND?
To set the radio band as an array:
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND
<enum>,<enum>,<enum>,…
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND?
The array form of the command is used to make a different setting for each
acquisition in the sequence (the number of array values must match the
number of acquisitions; otherwise a "settings conflict" error will occur).
SCPI Examples (for specifying
an EDGE radio band)
:LSEQ:ACQ2:SET:RAD:BAND NONE
:LSEQ:ACQ2:SET:RAD:BAND?
:LSEQ:LIST:SET:RAD:BAND PGSM,NONE,GSM850,PGSM
:LSEQ:LIST:SET:RAD:BAND?
SCPI Command (for specifying
a WCDMA/HSPA radio band)
To set the radio band as an individual value:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND
NONE|BANDI|BANDII|BANDIII|BANDIV|BANDV|BANDVI|BANDVII|
BANDVIII|BANDIX|BANDX|BANDXI|BANDXII|BANDXIII|BANDXIV
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:BAND?
To set the radio band as an array:
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND
<enum>,<enum>,<enum>,…
[:SENSe]:LSEQuencer:LIST:SETup:RADio:BAND?
The array form of the command is used to make a different setting for each
acquisition in the sequence (the number of array values must match the
number of acquisitions; otherwise a "settings conflict" error will occur).
SCPI Examples (for specifying a
WCDMA/HSPA radio band)
:LSEQ:ACQ2:SET:RAD:BAND NONE
:LSEQ:ACQ2:SET:RAD:BAND?
:LSEQ:LIST:SET:RAD:BAND BANDII, NONE, BANDIII, BANDXII
:LSEQ:LIST:SET:RAD:BAND?