Technical data

Chapter 9 109
Sequence Setup Commands
Programming Analyzer Sequences (Combination Commands)
Sequence Setup Commands
Notes The parameters are:
<enum> - specifies the Radio Standard for the Acquisition.
<enum> - specifies the Radio Band for the Acquisition.
<enum> - specifies the DeviceType for the Acquisition.
<real> - specifies the Frequency or Channel Number for the Acquisition. The
channel number and frequency are combined to one parameter. If the radio band
is set to NONE, this value is interpreted as a frequency value in Hz. If the radio
band is set to a valid band, this value is interpreted as a channel number.
<integer> - specifies the Number of Averages for the Acquisition.
<ampl> - specifies the peak expected power in dB for the Acquisition.
<enum> - specifies the Instrument Gain Type for the Acquisition (this parameter
does not apply to Model E6640A).
<time> - specifies the Transition Time for the Acquisition.
<time> - specifies the Duration of the Acquisition.
<enum> - specifies the Input Trigger Type for the Acquisition.
<ampl> - specifies the Input Trigger Level for the Acquisition.
<time> - specifies the Input Trigger Delay for the Acquisition.
<enum> - specifies the Output Trigger for the Acquisition.
<relative ampl> - specifies the dB value of Instrument Gain when Instrument
Gain Type is set to LOW (this parameter does not apply to Model E6640A).
<enum> - specifies the step Multiport Adapter Input path selection for the
Acquisition.
<enum> - specifies the step Multiport Adapter Preamplify On/Off state for the
Acquisition (this parameter does not apply to Model E6640A).
<enum> - specifies the specify the Acquisition Integration (for frequency span
extension or dynamic range extension) of the Acquisition.