Technical data

108 Chapter 9
Sequence Setup Commands
Programming Analyzer Sequences (Combination Commands)
Sequence Setup Commands
Programming Analyzer Sequences (Combination Commands)
Analyzer sequence parameters can be set as a group (using a pair of combination commands which set
all of the acquisition parameters and analysis step parameters for an acquisition) or independently (using
a larger set of parameter-specific commands). This section describes the combination commands.
Acquisition Parameters (Combination)
The parameters for an acquisition can be set by means of a single SCPI command, as described below.
To set just one parameter (for a single acquisition, or for all acquisitions in the sequence at once), see
“Acquisition Parameters (Parameter-Specific Commands)” on page 111.
Remote Command [:SENSe]:LSEQuencer:ACQuire[1]|2|3|4...512:SETup
NONE|GSM|EDGE|WCDMA|CDMA2K|CDMA1XEV|LTE,
NONE|PGSM|EGSM|RGSM|DCS1800|PCS1900|TGSM810|GSM450|
GSM480|GSM850|GSM700|BANDI|BANDII|BANDIII|BANDIV|BANDV|
BANDVI|BANDVII|BANDVIII|BANDIX|BANDX|BANDXI|BANDXII|
BANDXIII|BANDXIV|USCELL|USPCS|JAPAN|KOREAN|NMT|IMT2K|
UPPER|SECOND|PAMR400|PAMR800|IMTEXT|USPCS1DOT9G|AWS|
US2DOT5G|PUBLIC|LOWER|BAND1|BAND2|BAND3|BAND4|BAND5|
BAND6|BAND7|BAND8|BAND9|BAND10|BAND11|BAND12|BAND13|
BAND14|BAND17|BAND18|BAND19|BAND20|BAND21|BAND24|
BAND25|BAND26|BAND27|BAND28|BAND31\BAND33|BAND34|BAND35|
BAND36|BAND37|BAND38|BAND39|BAND40|BAND41|BAND42|BAND43|
BAND44|BANDA|BANDB|BANDC|BANDD|BANDE|BANDF,
BTS|MS,<real>,<integer>,<ampl>,
LOW|ZERO|HIGH,<time>,<time>,IMMediate|VIDeo|INTernal|
EXT1|EXT2,<amptd>,<time>,NONE|INT,<relative ampl>,
OFF|RFIO0|RFIO1|RFIO2|RFIO3|RFIO4|RFIO5|RFIO6|RFIO7,
ON|OFF,NORMal|PRIMary|LOWer|UPPer|RANGe
[:SENSe]:LSEQuencer:ACQuire[1]|2|3|4..512:SETup?
Example :LSEQ:ACQ1 GSM, PGSM, MS, 10, 10, 0dB, LOW, 5ms, 50ms, VID, –10dBm,
0, NONE, -20, RFIO0, ON, NORM
:LSEQ:ACQ1?