User`s guide

98 Agilent E6474A User’s Guide
4 Use Your System
accept the results of the Refresh Port action. The navigator,
however is not automatically enabled. Before you begin logging
data or Live Mode, verify the following:
• Verify that each phone, scanner, or receiver is enabled. Click
the check box to enable the NMEA Navigator. The navigator
supplies data to plot your position on the Route Map.
• Click the check box to enable the In-Building Navigator if you
have E6474A, option 030, indoor mapping. This allows you to
use the In-Building Route Map for manually plotting your test
route.
• Click the check box to enable the Simulated Navigator when
you need to isolate a problem, and do not require real
navigation data.
System with an E6473B High Speed Direct Connect Hub
If your system is equipped with an E6473B High Speed Direct
Connect Hub, you must:
1 Connect the phones to the Phone ports.
2 Power the Direct Connect hub On.
3 Have the E6473B driver software already installed. For the
E6473B driver installation procedure, refer to document
E6473B-90067, Important Information About the E6473B
Agilent High Speed Direct Connect Hub. This document is
shipped with the E6473B system, and the latest version is
also available at http://www.agilent.com/cm/wireless/e6474
/download.shtml.,
Limitations of the E6473B High Speed Direct Connect Hub
The following are limitations of the Direct Connect Hub, when a
dual port data phone such as a Sagem OT96, Samsung X100,
Samsung X1200 Samsung A399, or Kyocera 2235 phone is
connected to it:
NOTE
Make a note of the COM ports to which the data devices are connected. If
you are unfamiliar with how COM ports are assigned, refer to document
E6473B-90067. The section entitled, “Understanding and Organizing COM
Ports” details how COM ports are assigned in Windows systems.