User`s guide

Set Up Your System 3
Agilent E6474A User’s Guide 85
1 Connect the battery charger cable to the battery.
2 Plug the battery charger’s AC power cord into a 100-240V AC
50-60 Hz power source.
3 Allow approximately three hours to fully charge the battery.
Using Vehicle Power
See “In-Vehicle System Set Up" on page 31 for power cable
installation and connection instructions.
Safe Handling and Disposal
For the safe use of lithium-ion batteries, always follow the
instructions provided below. Improper handling of lithium-ion
batteries may result in injury or damage from electrolyte
leakage, heating, ignition, or explosion. Batteries must be
recycled or disposed of properly.
WARNING
Never charge the battery when the E6473B High Speed Direct
Connect Hub is powered on. Use only the approved charger, part no.
E6473-60009.