User`s guide

Set Up Your System 3
Agilent E6474A User’s Guide 61
Portable System Cable Connections
Cable connections to the rear panels should be made before the
E6473B High Speed Direct Connect Hub, the battery pack, and
the optional Scanner are loaded into the carry bag. Cable
connections to the front panels can be made after the
components are inserted into the carry bag. If the system is not
equipped with a scanner or receiver, no cable connections are
made to the rear panel of the E6473B High Speed Direct
Connect Hub.
An E7468A Dual Band Scanner has two RF antenna connectors.
Labels on the front panel identify the bands.
Phone Only System
This section describes the cable connections for a portable
system equipped with a phone. This configuration is housed in
the carry pack hub kit, E6473B option 022 .
Chassis Assembly
1 Rotate the locking knobs horizontally to allow devices to
slide into the slots of the chassis.
2 Insert the Hub into the top slot of the chassis.
3 Insert the battery into the bottom slot of the chassis.
4 Rotate the locking knobs to a vertical position, and tighten
the screws.
NOTE
Refer to Appendix D, “System Information", for antenna and phone
interface cable part numbers.
NOTE
The battery is keyed, and can only be properly inserted into the chassis
when the connectors are aligned.