User`s guide

58 Agilent E6474A User’s Guide
3 Set Up Your System
External Antennas
The following phone interface kits include antenna adapters. If
your system includes one of the phone interface kits listed in
“Adapters used in kits" on page 58, follow these steps:
1 Connect the antenna adapter to the phone.
2 Connect the antenna extender cable (E6473-60105) to the
appropriate adapter, if necessary. (Two adapters are
included with the antenna kit). The antenna extender cable
connectors are both FME female type.
3 Connect the antenna to the extender cable.
4 Mount the antennas on the roof of the vehicle, with at least
18” (approx. 46 cm) between antennas.
Tabl e 1 Adapters used in kits
Pulse Trigger Device
The E6455A, E6456A, and E645xC receivers accommodate a
pulse trigger device. The device you use must meet the following
receiver input requirements:
• Cable with BNC male connector (the Agilent pulse trigger
cable input is female BNC)
• Falling-edge triggered
• TTL threshold
Phone interface kit
part number
Use with phone(s) Adapter part number Adapter type
E6473-803 QCP 860, 1960, and 2760 E7483-60002 TNC female
E6473-830 Nokia 61xx E7484-60023 FME male
Phone antenna kit part
number
Use with frequency bands TNC male to FME male
adapter part number
FME male to FME male
Adapter part number
E6473-898 900/1800 MHz E6473-60101 E6473-60102
E6473-899 800/1900 MHz E6473-60101 E6473-60102