User`s guide

Set Up Your System 3
Agilent E6474A User’s Guide 53
Single E645xx Receiver Connections
Refer to Appendix D, “System Information,” starting on page
179 for antenna part numbers.
1 Connect the D-shell connector end of the data/power cable
(E6473-60006) to the
RS-232 port of the receiver.
2 Connect the power plug of the data/power cable to the 9-34
VDC connector of the receiver.
3 Connect the antenna cable for the receiver to the RF INPUT
connector.
4 If you have a cdmaOne or cdma2000 receiver, connect the 1
PPS cable (86156-60004) to the GPS RS-232 port.
Second E645xx Receiver Connections
1 Connect the power plug of the second receiver power cable
(E6473-60091) to the 9-34 VDC connector.
2 Connect the short Rx Loop cable (E7450-60001) to the RX
LOOP IN port of Receiver # 1.
NOTE
Refer to Appendix D, System Information, for antenna and phone interface
cable part numbers.