User`s guide

40 Agilent E6474A User’s Guide
3 Set Up Your System
E746xx Scanner Connections
Refer to Appendix D, System Information, for antenna part
numbers.
1 Connect the opposite end of the scanner data/power cable
(E6473-60083) to the
SCANNER port on the rear panel.
2 For a single band scanner, connect the antenna cable to the
antenna connector on the front panel.
3 For a dual band or PN scanner, connect the lower band RF
antenna cable to the lower antenna connector on the front
panel.
4 For a dual band or PN scanner, connect the upper band RF or
GPS antenna cable to the upper antenna connector on the
front panel.
Figure 5 Peripheral connections