User`s guide

38 Agilent E6474A User’s Guide
3 Set Up Your System
Cable Connections
Direct Connect Hub with Scanner
Before you connect the cables, install the power, USB data,
phone extender, and antenna cables, then route them through
the vehicle. (See Appendix E, Permanent In-Vehicle Hardware
Installation, for instructions.) Figure 3 shows the direct connect
hub connected to the scanner and then connected to the laptop.
E6473B High Speed Direct Connect Hub Connections
1 Connect the scanner data/power cable (E6473-60083) to the
RECEIVER port on the rear panel. See Figure 4.
Figure 3 Direct connect hub connected to a scanner
NOTE
Refer to Appendix D, “System Information", for antenna and phone
interface cable part numbers.
NOTE
If your system includes two Direct Connect Hub units, see “Connecting
Two Direct Connect Hub-Systems" on page 55.