User`s guide

32 Agilent E6474A User’s Guide
3 Set Up Your System
the serial port without an adapter when an OEM cable is
used.)
3 Connect the 9-to-26 pin adapter to the serial port of the
computer.
E64xx Receiver Only
1 Connect the receiver’s interface cable to the RS-232 port of
the receiver. Connect the opposite end of the cable to the
serial port of the computer.
2 Connect the power cable to the 9-34 VDC socket of the
receiver. Connect the opposite end of the cable to the battery.
3 If equipped, connect the GPS antenna to the GPS ANTENNA
connector.
Two-Phone Portable System
Dual Serial Port PCMCIA Card
If your system includes multiple devices but does not include an
E6473B High Speed Direct Connect Hub, at least one dual serial
port PCMCIA card is required. Two devices may be connected to
each card. The Dual Serial Port PCMCIA card is required for the
following system configurations:
• A system with two or more phones that does not include an
E6473B High Speed Direct Connect Hub. In this case, connect
each phone to a Serial port of the card.
• A system equipped with one Direct Connect Hub that has
more than three phones. (The Direct Connect Hub has two
Phone ports, and your computer may have a Serial port that
can be utilized.) In this case, connect each additional phone
to a Serial port of the card.
• A system with one phone collecting both data and trace
measurements that does not include the E6473B high speed
direct connect hub.
Refer to the manufacturer’s instructions if you need to install
the Dual Serial Port PCMCIA card: