User`s guide

210 Agilent E6474A User’s Guide
E Permanent In-Vehicle Hardware Installation
Direct Connect Hub Installation
Follow the instructions in this section to install the Agilent
E6473B High Speed Direct Connect Hub. If you system includes
the Agilent direct connect GPS DR, go to “Communicating with
the Agilent Direct Connect GPS/DR" on page 45.
In-Vehicle Rack Installation
1 Place the in-vehicle rack in the desired location.
2 Using an appropriate-sized nut driver, electric screwdriver,
or drill with screwdriver bit, drive in each of the four #10
self-drilling tapping screws.
Figure 74 In-Vehicle Rack for Direct Connect Hub