User`s guide

GPS Connections for E74xx Systems B
Agilent E6474A User’s Guide 167
3 Connect the RF antenna to the RF input of the Agilent E645x
receiver. Use the supplied Type-N to TNC adapter, if
necessary.
4 Connect one end of a standard, straight-through, RS-232
9-pin cable to the GPS RS-232 port of the Agilent E645x
receiver. Connect the other end of the RS-232 cable to the
Trimble Placer GPS 400 or SV6 connector.
5 Connect the GPS antenna to the GPS ANT port of the Trimble
Placer SV6/Placer GPS 400 unit.
6 If equipped, connect the phone interface cable to the phone.
Connect the opposite end to an unoccupied port of the Dual
Serial Port PCMCIA card.
7 Connect the power cables to the Trimble Placer GPS 400 or
SV6 and the computer. Connect the lighter plug for each
device to the 4-to-1 lighter socket adapter.