User`s guide

Get Ready 1
Agilent E6474A User’s Guide 15
Computer Hardware and Software Requirements
The following are the recommended computer requirements:
• 400 MHz Pentium processor or higher
• 128 Megabytes of RAM or higher
• 1 USB port (for systems equipped with the E6473B High
Speed Direct Connect hub)
• 1 serial port per test mobile (for a phone connected directly
to a serial port)
• 1 parallel port (for the software license key, if the computer
is not equipped with a USB port or if the USB port is being
used for the E6474A Direct Connect hub)
• 2 PCMCIA slots
• 1 Gigabyte hard drive or higher
• 800 x 600 display resolution (or 1024 x 768 for generic data
measurements)
Item Information/Requirements
E6474A software Compatible with Windows 95 (for direct connect phones
only), 98, 2000, and ME. Persons using this software
should be familiar with the Windows user interface. These
recommendations are subject to change as new
functionality is provided in the product.
Dual serial port
PCMCIA (Socket
I/O) card
Required for a system equipped with multiple phones,
each of which is connected to a computer serial port. The
Socket I/O card is included with the phone, and
combination phone and receiver/scanner software
licenses.
E6473B High
Speed Direct
Connect Hub
Enables communication with the software via the
computer’s USB port. Two phones, a DTI scanner or up to
two Agilent receivers, and a GPS navigator can be
connected to the Direct Connect Hub. The Direct Connect
Hub eliminates the need for the Socket I/O cards.