User`s guide

120 Agilent E6474A User’s Guide
4 Use Your System
Tes t 7 - P h o ne Te s ting U s i ng a Tes t C a l l
Setting Up the Hardware
1 Connect the system components per the instructions in
Chapter 3.
2 Power the system on.
Testing t h e Pho n e
1 Start the E6474A software.
2 Refer to “Identifying the Devices" on page 94, and perform
the procedure if you have not already done so.
3 Configure the Autodialing options in the Properties dialog
box. Click Help in the dialog box for instructions.
4 Open the view that shows signal parameters:
5 For CDMA, click View > CDMA Phone Status.
6 For GSM, click View > GSM Signal.
7 For iDEN, click View > iDEN Signal Parameters.
8 For TDMA, click View > IS 136 Phone.
9 Click View > Call Stats to open the call statistics view.
10 Click Log > Start Logging.
Passing the Test
In the signal parameters view, you should see an indication of
signal strength and other air interface parameters. The Call
Stats view indicates the call progress and call termination
results. If all calls are logged as “blocked,” verify that service for
the phone has been activated, and that the phone’s battery is
fully charged. Also recheck all cable connections.
• Click Log > Stop to end the test.