User`s guide

108 Agilent E6474A User’s Guide
4 Use Your System
Tabl e 3 Signal Generator Uplink Settings
Preparing the Software
1 Start the E6474A software.
2 Refer to “Identifying the Devices" on page 94, and perform
the procedure, if you have not already done so.
3 Click Log > Start Live Mode.
4 Open the Spectrum Analyzer view and maximize the view.
5 Connect the signal generator output to the RF input of the
receiver.
6 Turn on the signal generator.
7 Set the measurement software as follows:
You should see a signal trace showing a single spectral peak in
the middle of the display, as shown in Figure 46 on page 109.
Model Frequency and Power Setting
GSM1900, TDMA, cdma2000 and CDMA PCS
band systems
1879 MHz at –60 dBm
GSM DCS1800 band systems 1748 MHz at –60 dBm
GSM900 band systems 898 MHz at –60 dBm
Cellular CDMA and TDMA band systems 837 MHz at -60 dBm
1950 MHz at –60 dBm