User`s guide

102 Agilent E6474A User’s Guide
4 Use Your System
Configuring Data Device Properties
To perform throughput and timing calculations, you should use
Agilent Data Server Software. For more information on this
software and how it works, refer to the Agilent Data Server
software installation guide (E7475-90012).
Before you can perform a test with the data server, you must
configure the properties of the Data Devices added to the Data
Port. The Properties dialog box for the Data Device allows you
to configure the test conditions and parameters. See
“Configuring the Devices" on page 103 for instructions on
opening this dialog box.
Figure 43 Data device added
NOTE
Although the Agilent E6474A software shows the COM port in the System
Setup view that the data device is connected to, that COM port cannot be
used for configuring the device’s properties. Data Device properties can
only be configured by right-clicking on the Data Device, then choosing
Properties from the pop-up menu.