User`s guide
Use Your System 4
Agilent E6474A User’s Guide 101
2 Open the browser on the computer.
3 Attempt to browse the WEB.
4 If this test is successful, then start the E6474A software, and
proceed to Adding a Data Device.
Adding a Data Device
Use the Data Port in the System Setup view to set up the device
and data properties. In the System Setup view, up to four
Devices can be added to the Data Port. Properties for the data
device can then be configured, in a manner similar to a phone.
To add a device to the Data Port:
1 Right-click on the Data Port. A pop-up menu appears, as
shown in Figure 42.
2 Choose Add Device from the pop-up menu. After you add the
Data Device, it is enabled, as indicated by the check mark
next to Data Device in Figure 43.
Figure 42 Adding a data device