Technical data

10 Agilent Mobile Voice MOS Test Application Getting Started Guide
1 Setting Up
Setting up the Mobile van equipment
To set up the equipment in the mobile van:
1 Install and configure your USB Audio Module. Refer to
manufacturers instructions for more information.
2 Connect the phone ear- port to the Analog In, Channel 1
of the USB Audio Module.
3 Connect the phone microphone- port to the Analog Out,
Channel 1 of the USB Audio Module.
4 Connect the phone trace- port to your laptop.
5 (optional) Repeat steps 2-4 if you wish to use more than
one phone
Refer to Figure 3 on page 11 for a typical one phone mobile
van configuration.
NOTE
You need specific phone connection cables to provide these connections.
Refer to the supported phone list provided with the E6474A Wireless
Network Measurement Software (Supported phone list can be found in
the Library).