Specifications

Hardware

Outdoor GPS navigation support

The Agilent E645xC range of receivers include GPS navigation capability. The Agilent

Direct Connect GPS, with dead reckoning is also available as E6473B-030 (with mag

mount antenna) and E6473B-031 (with permanent mount antenna) options.

The E6474A 0ptimization platform supports TAIP, TSIP and NMEA compatible third party

GPS receivers including Trimble Placer GPS 455 receiver with dead reckoning and Garmin

II.

The key features of the Agilent supplied GPS receivers are tabulated below:

E645xC receivers Agilent E6473B-030 and -031

• 8 channel GPS receiver • 12 Channel GPS receiver

• Mounted inside Agilent RF • Dead reckoning

receiver enclosure • Heading sensor

• SMA antenna connector • Interconnect cables to Direct Connect

• Bulkhead mount antenna with cable hub interface

• Magnetic mount antenna with cable • Magnetic or permanent mount

• Differential compatible antenna option

• Not dead reckoning

compatible

Note: With the Agilent E645xC receivers, an external GPS source may be used with the

receiver even though an internal GPS exists within the receiver housing. This is valuable

when differential or dead reckoning measurements may be needed. Only one GPS source

can be used at any given time.

Test mobile phone hardware

The E6474A system software can control up to four test mobile phones. If more than one

test mobile phone needs to be controlled simultaneously, it is necessary to have the

E6474A-010 multiple phone software license.