Specifications

 1.25 MHz characteristic

 5 MHz characteristic (options #360, #361 only)

Aging of TCXO

 ± 1 ppm/year

Amplitude

Accuracy

 Accuracy for cellular band, PCS band, and Japan cellular band receiver

30 kHz IF bandwidth

 ± 0.5 dB typical from –25dBm to –110 dBm 1.25 MHz IF bandwidth

 ± 0.5 dB typical from –25dBm to –110 dBm

Noise figure

 8 dB typical

Internally generated spurious, input referred

-120 dBm for 30 kHz IF Bandwidth

-120 dBm for 1.25MHz IF Bandwidth

Adjacent channel desensitization

-25 dBm typical

Adjacent channel rejection

45 dB typical

• Accuracy for IMT 2000 band receiver

1.25 MHz IF bandwidth

 ± 0.5 dB typical from –25dBm to –110 dBm

5.0 MHz IF bandwidth

 ± 0.5 dB typical from –25dBm to –100 dBm

Noise figure

 8 dB typical

Internally generated spurious, input referred

 -120 dBm for 1.25MHz IF Bandwidth

 -115 dBm for 5MHz IF Bandwidth

1. Spectrum measurement allows tuning ±10 MHz above and below specified frequency ranges. In addition,

for the IMT-2000 band receiver (option #360 and #361), the PHS band is also covered (down to

1895MHz). These extended ranges are shown in brackets – [ ]. The performance is not specified in these

extended ranges. Characteristic noise floor increase is 2 dB ±10 MHz. For the IMT-2000 band receiver, at

–25MHz with respect to specified range, the characteristic noise floor increase is 5dB. Characteristic

amplitude accuracy is unchanged with respect to specified range.

2. Korea PCS band receiver and IMT-2000 band receiver does not have 30 kHz IF bandwidth. Korea PCS

band receiver has a 200 kHz and a 1.25 MHz IF bandwidth. IMT-2000 band receiver has a 1.25 MHz and

a 5 MHz IF bandwidth.

3. It is recommended that the input signal level not exceed –40 dBm.

4. Adjacent channel desensitization applies to the 1.25 MHz IF filter and is defined as the 1 dB compression

of tuned signal with interfering signal +/-1.25 MHz from tuned signal.