Specifications

29
 Assignment Status – Indication if UATIAssignment message was received
 RATI – Random Access Terminal ID (RATI) used for opening a session
 Attempt Duration – Time (in slots) taken to complete the attempt
 Successful Attempts – Counter for total number of successful attempts to open a
session
 Failed Attempts – Counter for total number of failed attempts to open a session
 Total Attempts – Counter for total number of attempts to open a session since power-
up
 Assigning PN – PN of the sector that sent the UATIAssignment message
Connection Release (CR) Info
 CR Reason – This represents the reason for a call termination
1xEVDO Signal Quality
This view provides a composite view of both the Fwd and Rev link RF quality and the
resulting data throughput. You can compare the requested data rate against the average
Fwd link throughput and the effective Fwd link received rate along with the Rev link
throughput. The view also displays the AT’s current RF mode and connection status.
Graphical bar charts on the lower half of the view provided Ec/Io and SINR values as
measured in the AT. The top six active set PNs are displayed along with the candidate
and neighbor set information.
 RF Mode – Current mode of the RF hardware
 Searcher State – Displays the current state of the searcher
 AT State – Summary of access terminal states
 AT Reg DRC Rate – The DRC rate requested by the AT
 Avg Fwd Link T’put – This is a calculated value based on counters of the good and
bad DRC frames received for each rate
 Channel # – Center frequency channel
 Channel Code – Walsh ID used
 PN – DRC cover of the serving pilot
 HO Cell Count – Number of cells involved in the soft handoff
 Rx0 Power – Total receive power as seen by antenna 0
 Rx1 Power – Total receive power as seen by antenna 1
 ARQ Eff Rec Rate – Data rate at which the traffic channel packet was decoded