Specifications

26
 ARQ Eff Rec Rate – Forward link data rate based on ACK and early termination.
 RAB Offset - Frame offset for the RAB sent over the forward link
 PER(Short) – Packet Error Rate calculated over 1000 slots
 PER(Long) – Packet Error Rate calculated over 10000 slots
 Req Data Rate(Short) – Averaged over 1000 slots
 Req Data Rate(Long) – Average rate over 10000 slots
 Pkt Received Flag – Indication if packet received in last 16 slots
Reverse Link
 Avg Rev Traffic Tput – Average rate data is sent on reverse link
 Act Rev Link Rate –
 Curr Rev Link Rate – rate which AT sent last packet
 Rev Rate Limit – Rate limit value sent in the overhead message
 DRC Channel Gain – Ratio of the power level of the DRC channel to the power level
of the reverse traffic pilot channel
 ACK Channel Gain – Ratio of the power level of the ACK channel to the power level
of the reverse traffic pilot channel
 AT Req DRC Rate – Represents the DRC Rate requested by the AT
 ACK/NACK Status – Denotes if the ACK channel is enabled or disabled
 ACK/NACK Value – Identifies if ACK or NACK was transmitted on the reverse link
1xEVDO Reverse Power Control
 Rx AGC – received signal strength
 Tx Total Limited – total Tx limited power
 Tx Adjust – Tx Closed loop adjustment value
 Tx Pilot – Tx Pilot power
 Max Tx Power RRI – Max RRI recommended value
 DRC Lock Period – Indicates number of slots DRC is locked
 RPC History Summary – Summary of Reverse power control bits for last 10 frames
 DRC Channel Gain – Value reported
 ACK Channel Gain – value reported
 Data Channel Gain – value reported
 Pilot Channel Gain – value reported
 DRC / Pilot – Channel to pilot ratio
 ACK /Pilot – Channel to pilot ratio
 Data /Pilot – Channel to pilot ratio