Specifications

16
CDMA Quick Paging Channel
The General TA w/Supplemental Channel check box must be enabled on the Log Mask
tab of the CDMA Properties dialog box. This feature only works with phones that support
supplemental channel messages.
QPCH General Channel
 Channel – the channel number
 Rate – the Quick Paging Channel Rate (4800 or 9600)
 PN – the Pilot number
 Power Level – the Quick Paging channel power level, expressed in dB
 THI – the erasure threshold for Paging Indicator decision.
 THB – the bit threshold for Paging Indicator decision.
QPCH Bit Information Status
 Status – status values associated with each indicator bit entry. Values are:
- Indicator Entry Not Applicable
- Indicator Bit Not Detected
- Indicator Bit Detected
- Indicator Bit Erasure
- Indicator Bit Invalid
 Type – type values associated with each indicator bit entry. Values are:
- PI (Paging Indicator) Bit #1
- PI (Paging Indicator) Bit #2
- CCI (Configuration Change Indicator) Bit #1
- CCI (Configuration Change Indicator) Bit #2
- Indicator Bit Invalid
 Position – indicator bit position. This information is not valid for types of CCI. Values
are:
- SD IEngy – soft decision I channel bit energy
- SD QEngy – soft decision Q channel bit energy
- PI IEngy – I channel pilot energy
- PI QEngy – Q Channel pilot energy