User`s guide

90 Chapter 3
Screen Reference
MANUAL TEST (Synchronous Mode)
Measuring Screen Examples
Measuring: Peak TX Power/Burst Timing/Power Ramp
The actual measurement data are shown in enlarged numerals but the Power Ramp
result text is shown when the marker is placed at any point of its measured trace. If
the actual data exceeds the limits in the graph, one (or two for two fails) white
triangle marker indicates the failed position at the top of the graph frame. Any data
indicating a failure is highlighted.
While making continuous measurements, the Trigger Sing/Cont softkey is blinking
as shown in Figure 3-25. If Abort softkey is pressed, another softkey menu is
shown to activate the trigger mode, zooming and marker functions as shown in
Figure 3-26.
Figure 3-25 Measuring: Peak TX Power/Burst Timing/Power Ramp Screen
Softkey Menu
o Trigger Sing/Cont: Toggles the trigger mode between Sing
for single and
Cont
for continuous modes if the Abort softkey is pressed. In the continuous
mode, this softkey is highlighted blinking until the Abort softkey is pressed.
In the single mode, this softkey is highlighted for one measurement cycle
and the marker function is available with the Knob MKR/Cursor softkey.
o Abort: Stops continuous measurements and shows another softkey menu as
follows.