User`s guide

86 Chapter 3
Screen Reference
MANUAL TEST (Synchronous Mode)
MS Call or BS Call Measuring Screen
When the BS Call or MS Call softkey is pressed, the following Measuring screen
is displayed before proceeding to the Talk/RF Test step:
Figure 3-22 MS Call Measuring Screen
Figure 3-23 BS Call Measuring Screen
Softkey Menu
o Abort: Stops the measurement and returns to the MANUAL TEST:
Stand-by screen.
Explanation
If the MS Call softkey is pressed, the MS Call step in the test flow starts blinking
and the operation message “Executing a call setup from the mobile.” is shown.
When a proper call setup is made, the Talk/RF Test step starts blinking as shown in
"Talk/RF Test Measuring Screen" on page 88.
If the BS Call softkey is pressed, the BS Call step starts blinking, and the mobile
needs to respond to the Test Set, for example by pressing the
SEND key. The
operation message “Processing....” is shown and then the test sequence goes to the
Talk/RF Test step making it start blinking as shown in "Talk/RF Test Measuring