User`s guide

Chapter 3 85
Screen Reference
MANUAL TEST (Synchronous Mode)
3. Screen Reference
The following display fields remain blank on the lower screen at this state:
The RF ON annunciator at the screen lower right corner is displayed only when the
RF signal from the Test Set is present at the RF IN/OUT connector.
The instruction message “Press [BS Call] or [MS Call].” is shown. By pressing the
BS Call or MS Call softkey, the first Measuring screen is shown, and you can then
execute a test.
Display Field Description
IMSI:
Displays the International Mobile Subscriber Identity from the
mobile.
IMEI:
Displays the International Mobile Station Equipment Identity from
the mobile.
Dialed No.:
Displays the number dialed from the mobile.
Power Class:
Displays one of the defined factors. See "Power Classes" on page
184.
GSM Version:
Displays either Phase 1 or Phase 2 defined by the mobile.
RX Quality:
Displays the measurement result for the receiver characteristics.
RX Level:
Displays the measurement result for the receiver characteristics.
DC Current:
Displays the dc current consumed by the mobile at the connection
state.
ACT Tim ADV:
Displays the number of bits for the actual timing advance data.