User`s guide

Chapter 3 63
Screen Reference
AUTOMATIC TEST
3. Screen Reference
AUTOMATIC TEST
In this test mode, Pass/Fail test results on all test items in the table are
automatically obtained by configuring the Test Setup: Test Sequence screen and
the Test Setup: Test Condition screen in the CONFIGURATION mode. Once a
measurement cycle has been completed, detailed test results can be displayed by
selecting one of the Pass/Fail cells in the test item table.
NOTE Insert the test Subscriber Identity Module (SIM) in the mobile phone before
performing any test, because the Test Set will attempt to perform measurements
which are not generally permitted by usual SIMs.
The default state at power on is the previous setting stored in the internal memory
before power off.
When entering numeric values, the variable increment softkey menu is displayed.
Refer to “Variable Increment Softkey” and "Storing Two Numeric Values" on page
59.
Stand-by Screen
When the AUTOMATIC TEST softkey is pressed after power on, either of the
AUTOMATIC TEST: Stand-by simplified screen (Figure 3-7) or the
AUTOMATIC TEST: Stand-by detailed screen (Figure 3-8) is displayed,
depending on the previous setting of the Screen Simp/Detai softkey.
Figure 3-7 Stand-by Simplified Screen