User`s guide

Chapter 3 61
Screen Reference
Initial Screen
3. Screen Reference
Initial Screen
After power on, the initial screen can be used to select one of the function modes
as shown in Figure 3-6. Also, the firmware revision name currently installed and
the procedure selection field are shown.
To update the current firmware with the most recent one, refer to "How to Update
the Firmware" on page 165.
To recall one of the test procedures from your SRAM memory card, refer to
"Recalling a Test Setup File" on page 163.
To return to the initial screen from any function mode, press the Return softkey
(multiple times if necessary).
NOTE For Test Sets without Option 002, the SPECTRUM MONITOR and SIGNAL
GENERATOR softkeys are not available.
Figure 3-6 Initial Screen
Softkey Menu
o AUTOMATIC TEST: Displays the AUTOMATIC TEST: Stand-by screen
and its softkey menu. Refer to "AUTOMATIC TEST" on page 63.
o MANUAL TEST: Displays the MANUAL TEST: Stand-by screen and its
softkey menu. Refer to "MANUAL TEST (Synchronous Mode)" on page
80, "MANUAL TEST (Asynchronous Mode)" on page 102 if Option 002 is
installed, or "MANUAL TEST (GPRS Mode)" on page 118 if Option 040
is installed.
o SPECTRUM MONITOR: Displays the SPECTRUM MONITOR screen
and its softkey menu if Option 002 is installed. Refer to "SPECTRUM
MONITOR" on page 136.
o SIGNAL GENERATOR: Displays the SIGNAL GENERATOR screen and
its softkey menu if Option 002 is installed. Refer to "SIGNAL
GENERATOR" on page 143.