User`s guide

56 Chapter 3
Screen Reference
General Operation Guide
Screen Flow Chart
The following illustrations show the screen flow charts according to each function
mode. Each rectangle represents one screen with a different function mode,
measuring step and status, measurement result, and so forth. Figure 3-5 on page
57 is applicable only for Test Sets with Option 002 and Option 040.
Figure 3-4 Screen Flow Chart
INITIAL SCREEN
Stand-by (simplified)
Test Setup
Test Sequence
File Management
Stand-by (detailed)
Aborted (simplified)
Aborted (detailed)
Measuring (simplified)
Measuring (detailed)
Pass/Fail (simplified)
Pass/Fail (detailed)
Peak TX Power
Burst Timing/Power Ramp
Zoom
Phase Error/Frequency Error
Sensitivity/RX Quality/RX Level
DC Current
AUTOMATIC TEST
(a)
Stand-by (sync)
Measuring (sync)
Zoom
Peak TX Power/Burst Timing/Power Ramp
Phase Error/Frequency Error
Sensitivity/RX Quality/RX Level
DC Current
Spectrum Monitor
CONFIGURATION
CONFIGURATION
Firmware Update
MANUAL TEST (Synchronous Mode)
Test Condition
Standard (without options)