User`s guide

Chapter 3 53
Screen Reference
General Operation Guide
3. Screen Reference
• Controlling the marker: For the graphic displays in the MANUAL TEST
and SPECTRUM MONITOR modes, the Knob MKR/Cursor softkey is
defined to select either Cursor for cursor control or MKR for marker
control, whichever is underlined. If MKR
is selected, this knob controls the
marker position on a graphic display.
4. The
PRESET key is provided to reset the Test Set and display the initial screen
with the function mode softkey menu.
5. The RF IN/OUT N-type female connector is provided to connect the RF output
signal to the mobile under test or to receive the input signal from the mobile.
While the RF signal is output from this connector, the green lamp is lit. (This
lamp is INSTALLATION CATEGORY I.)
6. The AUX connector is provided for Universal DC Power Adapter (P/N:
E6392-60001) to supply dc power to the mobile under test through a cable.
7. The CONTRAST knob controls the brightness of the LCD screen.
8. The MEMORY CARD slot and the
EJECT key are provided to save to or load
from an SRAM memory card. Using the firmware update card, the current
firmware can be updated to the new revision.
9. The
LINE key toggles the power on and off. The green lamp is lit while the
power is on. (This lamp is INSTALLATION CATEGORY I.)