User`s guide

48 Chapter 2

Using Functions

Testing a Mobile with SPECTRUM MONITOR

This procedure describes a test on an E-GSM mobile phone using the SPECTRUM

MONITOR mode.

NOTE This section is applicable only for the Test Sets with Option 002.

Step 1. Turn the Test Set on and wait for its selftest routine to finish.

Step 2. Refer to “Preparation for Each Test” on page 22 for the procedures required before

starting the test.

Step 3. Set the mobile phone to transmit RF power.

Step 4. Press the SPECTRUM MONITOR softkey in the initial screen to obtain the next

SPECTRUM MONITOR screen.

Step 5. Rotate the CURSOR CONTROL knob and see how the circular cursor changes its

position.

At one field, press the CURSOR CONTROL knob, then rotate it. You see that field

changes its values. Press the CURSOR CONTROL knob to enter that value.

Step 6. Set the higlighted fields of the test parameters as shown in the above screen.

Step 6