User`s guide

40 Chapter 2

Using Functions

Testing a Mobile with MANUAL TEST (Asynchronous mode)

The following procedure explains a test on a dual band (GSM900 and DCS1800)

mobile phone with the MANUAL TEST asynchronous mode.

NOTE This section is applicable only for the Test Sets with Option 002.

Step 1. Turn the Test Set on and wait for its self test routine to finish.

Step 2. Refer to “Preparation for Each Test” on page 22 for the procedures required before

starting the test.

Step 3. Press the MANUAL TEST softkey mode in the initial screen to obtain the

MANUAL TEST: Stand-by screen.

Step 4. Press the Mode Sync

/Async softkey to select the Async (asynchronous) mode.

Step 5. Rotate the CURSOR CONTROL knob and see how the circular cursor changes its

position.

At one field, press the CURSOR CONTROL knob, then rotate it. You see that field

changes its values. Press the CURSOR CONTROL knob to enter that value.

Step 6. Set the higlighted fields of the TEST parameters as shown in the above screen.

Step 6