User`s guide

Chapter 2 35
Using Functions
Testing a Dual Band Mobile with MANUAL TEST (Synchronous mode)
2. Using Functions
Step 6. Specify the higlighted fields of the test parameters as shown in the above screen.
If you want to supply dc power from the Test Set to the mobile, set the DC Power
field to On and enter your desired voltage value. To do this, use the Universal DC
Power Adapter and an appropriate dc power cable to connect between the AUX
port of the Test Set and the mobile.
Step 7. Press the Return, CONFIGURATION, then Test Setup softkeys to obtain the Test
Setup: Test Condition screen shown below.
Step 8. Specify the highlighted fields of the test parameters as shown in the left side of the
above screen.
Step 9. Enter the appropriate limits in the cells of the test item table above.
Step 10. Repeat Step 8 to Step 9 to set the Test Condition screen by replacing DCS1800
with GSM900 in Radio Standard.
Step 11. After you have set all parameters as needed, press the Return, Return again, then
MANUAL TEST softkeys to obtain the MANUAL TEST: Stand-by screen shown
below. Check if the Mode Sync/Async softkey is set to Sync
.
Step 12. Turn the mobile on and wait for it to camp on displaying 001-01.
Step 13. Press the BS Call or MS Call softkey, then the MANUAL TEST: Measuring screen
is shown.
Step 8 Step 9