User`s guide

32 Chapter 2
Using Functions
Testing a Dual Band Mobile with AUTOMATIC TEST
Step 19. At the MS Call step, you are asked to call from the mobile. For example, dial a
number and press the
Call key of the mobile.
Step 20. At the Talk step, make a talk test and press the Pass or Fail softkey according to the
talk test result.
Step 21. As each step is running in the test flow, its corresponding test item field in the table
will blink. While the RF Test step is blinking, each of the test items is measured.
You can see how it is being done.
Step 22. At the MS Release step, you are asked to end call from the mobile. For example,
press the
End key of the mobile to terminate the call.
Step 23. At the BS Call step, you are asked to respond to the call from the Test Set. For
example, respond to it by pressing the
Answer key of the mobile.
Step 24. After completing the measurement, the next screen is displayed to show the test
results. In this case there is not a failure at those channels in the GSM900 and
DCS1800 bands.
Step 25. If a printer is available, print the test results.
Press the More (1 of 2) softkey and print as follows:
• Press the Print softkey to make a graphic image screen hardcopy.