User`s guide

Chapter 3 163
Screen Reference
CONFIGURATION
3. Screen Reference
Softkey Menu
o Save Execute: The operation message “OK to save?” is shown when this
softkey is pressed, and the Yes and No response softkeys are displayed.
Refer to Step 9.
o Cancel: Exits the save execute screen, and returns to the save/recall screen.
Step 9. Press the Save Execute softkey and respond to the operation message “OK to
save?” by pressing the Yes softkey. If there is something to revise, press the No
softkey to go back to Step 4.
Softkey Menu
o Yes: Stores a new setup file into an SRAM memory card. The operation
message “Saving...” is shown while saving. After saving, the save/recall
screen is displayed.
o No: Returns to Step 4 to restart editing File name and Comment.
Step 10. If the new filename and comment have been correctly created, the operation
message “Saving....” is shown for a while, and then returns to the File
Management screen.
Step 11. If saving is properly done, the new filename should be shown in the filename table
with the Date and Time data that are automatically taken from the internal clock of
the Test Set.
Step 12. If the Save Execute softkey and the Yes softkey are pressed when the filename has
been left blank, the operation message “The filename is improper. Press [Cancel].”
is shown and the Test Set beeps. Press the OK softkey to stop the beeps and go
back to Step 4.
Recalling a Test Setup File
For recalling one of the test setup files from an SRAM memory card, use the
following procedure:
Step 1. Insert your SRAM memory card into the MEMORY CARD slot to obtain the setup
file list.