User`s guide

Chapter 3 159
Screen Reference
CONFIGURATION
3. Screen Reference
o Over/Ins: Selects either Over (overwrite) or Ins (insert). Over enables you to
overwrite (erase and replace) the selected alphanumeric character. Ins enables
you to insert characters at the position of the rectangular cursor without erasing
the existing characters.
o Delete: Deletes the alphanumeric character selected by the rectangular cursor.
o Del End: (Delete to the End) Deletes all alphanumeric characters from the
rectangular cursor to the end of a message line.
o Bk Space: (Backspace) Erases one alphanumeric character behind the
rectangular cursor.
o Available alphanumeric characters and symbols are as follows:
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z _ 0 1 2 3 4 5 6 7 8 9
(space) a b c d e f g h i j k l m n o p q r s t u v w x y z ! “ # $ % & ‘ ( ) * + , - . /
: ; < = > ? @ [ \ ] ^ { | } ~
The following illustration shows the editing screen about to enter “g” to spell out
“being” overwriting the default message.
Step 4. If the created message is right, move the circular cursor back to Done and press the
CURSOR CONTROL knob once more to enter that message. The circular cursor
returns in front of the step number. Then, the message line is highlighted.
The default instruction messages at factory shipment are as follows:
1. Turn on MS power, wait for Location Update.
2. Make MS Call or respond to BS Call.
3. Talk to the mobile and press [Pass] or [Fail] with the result.
4. Wait for the RF Test to complete.
5. End call (for MS Call) or wait for call to end.
6. Respond to BS Call or make MS Call.
7. Wait for call to end (for BS Release) or end (for MS Release).