User`s guide

158 Chapter 3
Screen Reference
CONFIGURATION
Creating Instruction Messages
An instruction message with up to 69 characters including spaces and symbols can
be created for each step of a test flow to execute AUTOMATIC TEST. The range
of the step numbers is from 1 to 7 corresponding to each step of a test flow. Use the
following procedure to create an instruction message:
Step 1. Place the circular cursor in front of the input field of Instruction.
Step 2. Press and rotate the CURSOR CONTROL knob until the desired step number is
shown and press the CURSOR CONTROL knob to select it. Then, the whole
message line is displayed with the rectangular cursor on the first position, showing
a message if it is already stored. Check that the circular cursor is set to Done in the
Choices scrolling window.
Step 3. Create a message by rotating and pressing the CURSOR CONTROL knob to select
commands, alphanumeric characters, and some kinds of symbols from the
scrolling window.
The available commands and characters are as follows:
o Done: Enters the newly created instruction message in the instruction message
field.
o Cancel: Exits the editing function without any change of the message.
o Position: Allows you to move the rectangular cursor to any position of the
message for editing.