User`s guide

Chapter 3 157
Screen Reference
CONFIGURATION
3. Screen Reference
The following test items need to be set to either “Run” to execute a Pass/Fail test or
to “---” (skip) not to execute a Pass/Fail test, for each channel or dc power,
respectively:
When TCH is set in the Variable field and the all of test items are set to skip for
one TCH, only the handover capability can be tested for that TCH.
Test Item Description
Peak TX Power
Defines whether to run or skip the Peak TX Power test for the
High, Mid, and Low levels. The MS power class and the power
control levels for the High, Mid, and Low levels are defined in
the Test Setup: Test Condition screen.
Burst Timing
Defines whether to run or skip the Burst Timing test. In the
GPRS mode, this will be substituted by Power vs Time.
Power Ramp
Defines whether to run or skip the Power Ramp test. In the
GPRS mode, this will be substituted by Power vs Time.
Phase Error
Defines whether to run or skip the Phase Error test.
Frequency Error
Defines whether to run or skip the Frequency Error test.
Sensitivity
Defines whether to run or skip the Sensitivity test in BER and
FER. In the GPRS mode, BLER will substitute BER and FER.
The BS level and the number of test frames are defined in the
Test Setup: Test Condition screen.
RX Quality
Defines whether to run or skip the RX Quality test. In the GPRS
mode, this can not be measured.
RX Level
Defines whether to run or skip the RX Level test. In the GPRS
mode, this can not be measured.
DC Current
Defines whether to run or skip the DC Current test at Camp On
and Talk steps.