User`s guide

148 Chapter 3
Screen Reference
CONFIGURATION
Test Setup: Test Condition Screen
If the Test Setup softkey in the CONFIGURATION screen is pressed, the Test
Setup: Test Condition screen is displayed as follows:
Figure 3-62 Test Setup: Test Condition Screen
Softkey Menu
o Print: Allows you to print a hardcopy of a graphic image from the screen.
o Print All: Allows you to print a hardcopy set of the whole contents for the
CONFIGURATION, Test Sequence, and Test Condition screens for all
radio standards.
o File Management: Allows you to go to the File Management screen to store
a new test setup file into an SRAM memory card, or to load a test setup file
from an SRAM memory card. Refer to "File Management" on page 160.
o Test Sequence: This softkey toggles the screens between Test Sequence and
Test Condition.
o Return: Displays the CONFIGURATION screen and then the initial screen
with function modes.
NOTE For the GPRS mode with MANUAL TEST, the test limits for BER, FER, RX
Quality, and RX Level will not be effective.