User`s guide

124 Chapter 3
Screen Reference
MANUAL TEST (GPRS Mode)
Attached Screen
Upon completion of the attaching process, the following measuring screen is
shown. The Attached step in the test flow is blinking and the cursor is placed on
the first test item column.
Figure 3-45 Measuring: Attached Screen
Softkey Menu
o End: Returns to the MANUAL TEST: Stand-by screen.
o Abort: Returns to the MANUAL TEST: Stand-by screen.
NOTE As the connection state becomes on to begin measurements for a short period
immediately when one of the test items is selected, the Connect step stays
unchanged but the Attached step is blinking.
Explanation
In this mode, you cannot change the input fields of the Radio Standard, Procedure,
Multi Band, and DC Power supply mode. If the DC Power mode is set to On in the
Stand-by screen, the dc voltage field can be modified and DC Current in the test
item table is also highlighted to make measurements. Other highlighted fields can
be modified for a new test.
The operation message “Select an item column with [CURSOR CONTROL] to
execute its test.” is shown for making an RF test. Refer to "Procedure to obtain the
Measuring screens" on page 125.
The following display fields show the measurement data at this state on the lower
screen:
Display Field Description
DC Current:
Displays the dc current consumed by the mobile at the attachment
state
when the dc voltage is supplied to the mobile using
Universal DC Power Adapter
.
ACT Tim ADV:
Displays the number of bits for the actual timing advance data.